PC Parts

[Robert Flowers]

I have a PC #4210 dovetail jig and one of the teeth is bent :mad: don't know how. Its about 8 teeth in from the right side its bent to the left about 1/8" . So looked on Servicenet for a new template and maybe order one to make miniature dovetails. The thing is on Backorder until July 8,2011!
Man there must be a whole lot of dovetailing going on for PC sorry Stanley :rolleyes: to run out of templates. Does anyone know were i can order parts from other than Servicenet?

Robert

[Bruce Wrenn]

For what PC / Stanley is going to want to for part, you could buy a used jig. I only paid $75 for a used PC 4212 with TWO sets of extra bits, one of which was new Whitesides. These were in addition to the original PC bits.

[shane lyall]

Try ereplacementparts. I've ordered odds and ends from them for several years with good service.