PDA

View Full Version : Pinnacle Replacement Parts - X Axis Motor



Rhon Stuckert
03-11-2011, 3:27 PM
Are there any options to purchase replacement motors for a Pinnacle M Series other than signwarehouse?
All I have for information is what is on the motor which is Hansen Corp
116-33224-2 BK01359B MEVe(x). I can't seem to find reference to it on the web. Any help would be apprecitated.

Gary Hair
03-11-2011, 3:40 PM
I am sure there is but it may be hard to find. Often the manufacturer, GCC in this case, buys the components built to their own specs and you can't get those particular parts anywhere else. That said, it's unlikely that GCC did that with such a common part as a servo motor.

What exactly is the problem? I just had, last week in fact, a problem with my X axis and it was a simple matter of removing the cap over the encoder and cleaning it - back to normal and saved the $497 SW quoted me for a replacement...

Gary

Rhon Stuckert
03-11-2011, 4:10 PM
While lasering wood, the x axis literally just stopped moving. After turning the laser off, it still would not move. Eventually got the motor out though I noticed alot of little metal shavings so I assume a bearing is starting to go and I need to replace it.

Gary Hair
03-11-2011, 6:11 PM
is this the one?

http://www.jing-yang.com.tw/see_bpic.php?pd_nbr=52732

Richard Rumancik
03-11-2011, 9:40 PM
I'd go to GCC America. Try one of these options to contact them:

GCC America Inc.
323 Paseo Tesoro,
Walnut, CA 91789,
USA
Tol-free Number :
+1 888 284-5211
(US/Canada ONLY)
Tel : +1 909 718-0248
Fax : +1 909 718-0251
sales@gccamerica.com (sales@gccamerica.com)

Mike Page
03-12-2011, 12:43 PM
Try Jorlink. com . Talked to them three weeks ago and this motor was in stock.

Mike

Rhon Stuckert
03-12-2011, 1:38 PM
Gary- The number is correct and it looks like the one I need.
Richard and Mike - Thanks for the suggestions. I will look both of them up.