Annette Plamondon
03-10-2011, 11:31 AM
I am new to this laser engraving thing and I have had issues with the clarity and even-ness of some of the projects I do.
First, it seems the sides or edges of logos or whatever I am engraving come out clean and clear and the middle or center of it doesn't? Everything is flat and I just don't understand. :confused: I have wasted a lot of material.
Also, is there a way to get small logos to not look blurry? Is it about the lens size?
Thanks.
I attached a pic of the project I am working on, it does not show the detail the way I was hoping.
185925185926
First, it seems the sides or edges of logos or whatever I am engraving come out clean and clear and the middle or center of it doesn't? Everything is flat and I just don't understand. :confused: I have wasted a lot of material.
Also, is there a way to get small logos to not look blurry? Is it about the lens size?
Thanks.
I attached a pic of the project I am working on, it does not show the detail the way I was hoping.
185925185926