Troy Turner
02-28-2011, 1:19 PM
So I'm making my 2nd shadow box, and instead of using a straight bit like I did on the first one, I decide I want to use my rabbet bit in the router table to create the recess on the back.
The first one I did, I ran each piece individually and snuck up on my cut. Two of the pieces could go end to end, but the other two had to have stopped rabbets due to the design.
On the 2nd one, I said hey, I have a bit for this. Let's assemble the whole thing (a square) and run it on the router table.
I had no way to get any kind of dust collection what so ever anywhere near this and it was some kind of dirty. When I made my first pass and realized it was going to get dusty, did I do the smart thing and stop, reset the fence, take it apart, and run each piece individually????
NOPE, kept right on going...I inhaled enough dust to make a small shelf :D
If I do a 3rd one, each piece will be ran seperately, with the rabbet bit still, but all blowing towards the vac....
The first one I did, I ran each piece individually and snuck up on my cut. Two of the pieces could go end to end, but the other two had to have stopped rabbets due to the design.
On the 2nd one, I said hey, I have a bit for this. Let's assemble the whole thing (a square) and run it on the router table.
I had no way to get any kind of dust collection what so ever anywhere near this and it was some kind of dirty. When I made my first pass and realized it was going to get dusty, did I do the smart thing and stop, reset the fence, take it apart, and run each piece individually????
NOPE, kept right on going...I inhaled enough dust to make a small shelf :D
If I do a 3rd one, each piece will be ran seperately, with the rabbet bit still, but all blowing towards the vac....