Tom Rick
02-10-2011, 9:21 PM
Hello,
I have a job where I need to cut out a number of access panels out of veneer covered 3/4" ply. The cutouts need to be used for the panels.
When installed the panels need a 1/4" wood trim around the panel and around the cut out.
As pictured below:
182193
These hatches are in large panels which can not be brought to a table saw. I suppose I could cut out with a jig saw but I would like a cleaner technique for getting a square edge and fixed width of cutout around the panel for the wood trim.
Any ideals?
I have a job where I need to cut out a number of access panels out of veneer covered 3/4" ply. The cutouts need to be used for the panels.
When installed the panels need a 1/4" wood trim around the panel and around the cut out.
As pictured below:
182193
These hatches are in large panels which can not be brought to a table saw. I suppose I could cut out with a jig saw but I would like a cleaner technique for getting a square edge and fixed width of cutout around the panel for the wood trim.
Any ideals?