PDA

View Full Version : Fabrication and Shop Techniques Lathe Wrenches



Doug Wolf
02-03-2011, 3:34 PM
Here are a couple of wrenches I made to remove my NOVA chucks on my wood lathe. The bottom one fits the hex on the insert and the other will fit the flats on an extension I have on another chuck that is a little smaller size. They are just used to break the chucks free when I remove them. I don't tighten the chucks with them because the chucks just go on hand tight and a set screw keeps them from coming off in reverse. But they need a little persuading to remove.

181081