View Full Version : Frozen wood
kevin nee
02-02-2011, 11:37 AM
I have been reading a little about frozen wood. I have to make a bowl out of a 10" inch round by 16" long Walnut log that has been out side since cut.
Should I bring it inside for a couple days or just do it? I plan to do natural edge
and I have to have it done for the SUPER BOWL this Sunday.
Any input would be appreciated. I am in Massachusetts and it has been cold.
Thanks in advance,
Fred Perreault
02-02-2011, 12:15 PM
While you are waiting for answers, just bring it in to stabilize for a while... however long you can wait. It probably isn't going to get much drier, but it would be better to have it at shop temperature for a few hours, at least.
Nathan Hawkes
02-02-2011, 1:08 PM
You probably can leave it outside til just a few hours before you want to turn it; I've turned frozen wood before; it thawed very quickly. At the point of chisel contact, the ice sublimated into steam, which was pretty cool to see up close. One more thing that you need to consider; if your wood isn't sealed, it is going to start checking as soon as it is thawed out. This is a big benefit to leaving it out as long as possible.
Richard Madden
02-02-2011, 1:40 PM
Just turn away. I don't wait for wood to thaw. Hopefully it was sealed.
William Bachtel
02-02-2011, 3:17 PM
I like turning my N/E bowls when frozen. I find that the sapwood doesn't discolor, and it will leave less of a tooling mark. I also sand it frozen if I get it done in time. I wood also make sure it is 3/8 inch or thinner, less cracks , also don't heat up the bowl when sanding or it will crack for sure. Sand at low speeds, us open coat paper. Also I like the room temperture to be below 55 degrees, wood will stay frozen longer. Maple, Cherry, Walnut, wood with a white sapwood, can and will discolor fast when the temperture is above 55. This method will let you turn it start to finish with the least amount of problems.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.