Carroll Courtney
01-17-2011, 7:26 PM
Van,just like the other person in the pic I also made mine out of an older model unisaw rip fence and rails.Since the BS and Unisaw are both Delta then the holes for the rails will lineup w/the table on the BS.I cut the rails to what I wanted marking them while they were bolted to the table.The fence I cut to length and I had to also cut the rod that travels to the back of the fence for the lock,I had to use a threaded die for that task.It was easy,but you really only get one chance.I found rails and fences on ebay,but you have to make sure that their straight.That's a CP-20 Carter guide care of Bobby over at www.woodworkerstool.com (http://www.woodworkerstool.com) Just a thought-----Carroll