steven carter
01-17-2011, 2:05 PM
My MIL used to live next door to us before entering a nursing home and had 3 cedar trees, one of which was struck by lightning and had to come down. My wife wanted a HF made from it, so I gave it a try. After rough hollowing, and drying, it became very cracked. No problem I thought, I'll just fill in the cracks and see how it goes. It went alright... right off the lathe when I hollowed through the bottom. The fun of hand hollowing! Not being the kind to give up (even when I probably should), I decided to make a pedestal for it. The cracks were filled with both sanding dust and brass. The result ended up 11" tall and 5" in diameter. The finial slims down to .10" which may not be very thin for some, but is my thinnest yet. I made a Drozda style vortex tool which really helped with the transition from the point to the shaft, and also the gap under the bulb. The finial is 4" tall. I think it will look a little better when the cherry darkens more, right now not too much contrast. I decided to make the globe a lot more glossy than the pedestal and finial in hopes it would give some visual difference in the mean time, plus LOML likes cedar to be shiny. It ended up with a small gap between the collar and the globe which I don't like, but it is what it is. These HF's are addicting, I think I may need a hollowing system sooner than I thought, a laser would have come in handy on this one.
Thanks for looking, C&C welcomed.
Steve
Thanks for looking, C&C welcomed.
Steve