Rob Vicelli
01-15-2011, 11:18 PM
Well I have finally taken the time to go through my jointer and replace the blades. I bought this unit quite a few years ago at the Delta outlet after a wood show. I never really adjusted anything or checked it but it seemed to work OK.
The blades went in good and and the tables are even front to back. The problem is the infeed table is down .010 all the way to the right. They really dont mention this in the manual. They do talk about the gibs but for removing slack in the movment of the table.
Before I loosen and try the gibs has anyone done this on this jointer or one similar??
thanks
Rob Vicelli
The blades went in good and and the tables are even front to back. The problem is the infeed table is down .010 all the way to the right. They really dont mention this in the manual. They do talk about the gibs but for removing slack in the movment of the table.
Before I loosen and try the gibs has anyone done this on this jointer or one similar??
thanks
Rob Vicelli