Tim Morton
01-09-2005, 2:24 PM
I just recieved my Leeson 2HP DC motor and want to install it in my Jointer.Just want to run the wire diagram by you guys before I plug it in. OK, so on the case label there are 2 boxes next to each other with wiring instructions.
The box on the right (the way the motor is currently wired) says:
P1=Line
P2=Tape
T2-T3-T8=Tape
T4-T5=line
Nowhere does is say that this is set for 220v and this is my first motor install. Asuming it comes from Leeson wired for 220v I just need to know if the white white connects to P1 And Black to T4-T5 with green to ground. Thanks for your help, I am electrically challenged and the shop where I bought the motor is closed weekends.
The box on the right (the way the motor is currently wired) says:
P1=Line
P2=Tape
T2-T3-T8=Tape
T4-T5=line
Nowhere does is say that this is set for 220v and this is my first motor install. Asuming it comes from Leeson wired for 220v I just need to know if the white white connects to P1 And Black to T4-T5 with green to ground. Thanks for your help, I am electrically challenged and the shop where I bought the motor is closed weekends.