Jarrett Sadowsky
12-19-2010, 7:35 PM
Spent the last couple of weekends making Christmas presents. I had quite a long list when I started, and after reality set in I shortened it twice.
Made 6 biscuit cutters after seeing a post earlier this year. Turning the top would have been a lot easier if I had a vacuum chuck...maybe next year. ;) Ended up using a piece of all thread through the spindle holding the piece on through the "air hole". Finished with danish oil.
174467174468
Have been making a few pens lately as well. These three are Jr. Gentlemen II fountain pens from CSUSA. The one on the left is almond. The one in the middle is deer antler. The one on the right is a combination of the almond and deer antler. The cap also has a deer antler accent. This is my favorite one with the all antler a close second. They were finished with 20 coats of CA and micro meshed to 12,000.
174469174466
Made 6 biscuit cutters after seeing a post earlier this year. Turning the top would have been a lot easier if I had a vacuum chuck...maybe next year. ;) Ended up using a piece of all thread through the spindle holding the piece on through the "air hole". Finished with danish oil.
174467174468
Have been making a few pens lately as well. These three are Jr. Gentlemen II fountain pens from CSUSA. The one on the left is almond. The one in the middle is deer antler. The one on the right is a combination of the almond and deer antler. The cap also has a deer antler accent. This is my favorite one with the all antler a close second. They were finished with 20 coats of CA and micro meshed to 12,000.
174469174466