Darren Stinson
12-17-2010, 10:39 PM
I have a Spirit GE and when I work from the Home Position in the driver settings the 0,0 position is actually -0.2mm on the X and 0 on the Y. I determined this by moving the carriage on the control panel and setting it to 0,0 there and confirming on the rulers.
Is there a method to adjust the home position? Of course I can engrave using Relative or Smart Center but would like to have confidence that 0,0 on the X,Y really is 0,0. Any help would be appreciated. Thank you.
Darren
Is there a method to adjust the home position? Of course I can engrave using Relative or Smart Center but would like to have confidence that 0,0 on the X,Y really is 0,0. Any help would be appreciated. Thank you.
Darren