Problem with home position on Spirit GE

[Darren Stinson]

I have a Spirit GE and when I work from the Home Position in the driver settings the 0,0 position is actually -0.2mm on the X and 0 on the Y. I determined this by moving the carriage on the control panel and setting it to 0,0 there and confirming on the rulers.

Is there a method to adjust the home position? Of course I can engrave using Relative or Smart Center but would like to have confidence that 0,0 on the X,Y really is 0,0. Any help would be appreciated. Thank you.

Darren

[Scott Challoner]

If you have a login on the LaserproNA website, they have instructions for setting home. You log in and enter the support area and go to your machine.

[Marko Milosavljevic]

Just hold "Enter" button while powering on your machine and you will be able to set your home position.

[Darren Stinson]

Thank you Scott and Marko, my home position is where it needs to be now due to your assistance.