View Full Version : Problem with home position on Spirit GE

Darren Stinson
12-17-2010, 10:39 PM
I have a Spirit GE and when I work from the Home Position in the driver settings the 0,0 position is actually -0.2mm on the X and 0 on the Y. I determined this by moving the carriage on the control panel and setting it to 0,0 there and confirming on the rulers.

Is there a method to adjust the home position? Of course I can engrave using Relative or Smart Center but would like to have confidence that 0,0 on the X,Y really is 0,0. Any help would be appreciated. Thank you.


Scott Challoner
12-17-2010, 10:55 PM
If you have a login on the LaserproNA website, they have instructions for setting home. You log in and enter the support area and go to your machine.

Marko Milosavljevic
12-18-2010, 3:34 AM
Just hold "Enter" button while powering on your machine and you will be able to set your home position.

Darren Stinson
12-18-2010, 9:40 AM
Thank you Scott and Marko, my home position is where it needs to be now due to your assistance.