Finally turned some pendants

[John McCaskill]

I finally got around to turning some pendants using the Richard Joyner jig. These are 3 of my first 4 attempts. (One got away before the pictures). Turned, sanded (only a bit), then buffed with 3-wheel system. No other finish than buffing.

John

174025174026174028
Number one, two & three in order
174027174024
All three together

[Tony Pridmore]

Looking good. #3 is my favorite

[Steve Schlumpf]

John - looks like you are off to a great start - especially if one was gone even before the photos! Looking forward to seeing what additional designs you come up with.

[David E Keller]

Nicely done, John. That little jig sure lends itself to a lot of creative designs... I hope you continue to share your results.

[Baxter Smith]

Nice pendants John. I just tried some earlier this week. Getting different grooves on the same pendant the same depth was tougher than I would have thought. You did a great job!

[Bernie Weishapl]

The pendents look good. I like #3.