Bart Leetch
01-01-2005, 3:59 PM
I understand to adjust the miter Gage slot to the blade that the top needs to be loosened & moved in small increments until the blade lines up at both the back & front of the blade using the same tooth on the blade.
My saw blade is wide at the back on the right side between the blade & right miter slot. So do I loosen the 2 front bolts & the right rear bolt & move the front of the table to the left until the measurement is the same at both the front & back of the blade?
Thanks
My saw blade is wide at the back on the right side between the blade & right miter slot. So do I loosen the 2 front bolts & the right rear bolt & move the front of the table to the left until the measurement is the same at both the front & back of the blade?
Thanks