William Milligan
11-19-2010, 8:40 AM
I have noticed a few threads on engraving electronics and know it can be done quite well with our lasers. I have been approached by a numer of individuals regarding engraving the backs of their phones, etc. While I do know it seems to be fairly easy I also know it is a one time shot. If I mess it up it is messed up. So,
My thought is to put some clay, paper or some other substance on top of the item and do a dry run to make sure placement is correct prior to running the actual job. I figure I could run the job with limited power just to make an impression on the "template"...Any suggestions for tried and true methods for doing this? I am probably putting TOO MUCH thought into this but if I am going to do it I want to make sure it is done right. Thanks!
My thought is to put some clay, paper or some other substance on top of the item and do a dry run to make sure placement is correct prior to running the actual job. I figure I could run the job with limited power just to make an impression on the "template"...Any suggestions for tried and true methods for doing this? I am probably putting TOO MUCH thought into this but if I am going to do it I want to make sure it is done right. Thanks!