View Full Version : Anyone interested in 3/16 Sublimation FRP?

AL Ursich
11-13-2010, 3:31 PM
Only .090 White two sided Sublimation Plastic is available. I am looking into a special order of 3/16 two sided white FRP from Unisub. It would be a special order through Kevin or Don at Johnson Plastics.

They have not found the blanks to make it yet, but it is a possible. Could require 30 four by eight sheets......

I am just looking for thicker Tag Material.

Is anyone else interested in thicker FRP? Or am I the only FRP Obsessed Fool?:eek:

It could be used for things like Electrical Panels, Boat Dash Boards, and signage.


Albert Nix
11-14-2010, 8:23 AM
How are you going to cut it?

Mike Null
11-14-2010, 8:26 AM

Please excuse my moving your previous post. I completely mis-read it.

Albert Nix
11-15-2010, 8:26 AM
No problem Mike.

AL Ursich
11-15-2010, 9:15 PM
I use my CarveWright Toy CNC and a Carrier Board.... 1/16 inch bit.

Double stick tape for now. Building a Vacuum carrier board.

Had a bearing go out in the Y Axis while cutting this set of blanks...

New bearings and back up and cutting...:D

Got a box of FRP from McMaster Carr today to play with...:rolleyes: