Hannu Rinne
11-06-2010, 3:48 PM
My English is what it is, so I'll try to put my question as simply as I can...
I'm trying to engrave lace pattern around a glass (full 360 degrees) but I can't get the end's together in any way. The dia of the glass is 70,5mm which gives 221,37mm with pi. Print driver says that the image doesn't fit in the media, so I increased the dia up to 74mm and made the image just a bit longer - same result. I've cleaned the image so that there isn't any hidden borders - no matter what I'll try, just can't get the end's together - there's always about 10mm space between them... Does anyone have any idea what is going on :confused:
Regards, Hannu
I'm trying to engrave lace pattern around a glass (full 360 degrees) but I can't get the end's together in any way. The dia of the glass is 70,5mm which gives 221,37mm with pi. Print driver says that the image doesn't fit in the media, so I increased the dia up to 74mm and made the image just a bit longer - same result. I've cleaned the image so that there isn't any hidden borders - no matter what I'll try, just can't get the end's together - there's always about 10mm space between them... Does anyone have any idea what is going on :confused:
Regards, Hannu