Andy Maldoror
11-01-2010, 5:30 PM
i'm planning on building something like brian anderson's router cabinet, which is the third picture in this thread: http://www.sawmillcreek.org/showthread.php?t=146997 but it's probably going to be the length of the one in the first 2 photos.
i have an old unisaw with the 52" bies fence..a 7518 and router lift and i'm getting the 17" incra super system that will attach to the table top like keith's in the above thread.
is there a mobile base available that would work with this kind of setup? i was thinking delta until i realized the lifting castor wouldn't be accessible. i'd like to butt the cabinet as close as i can with the hand crank on the TS.
is this the project where i finally learn how to weld...or maybe a wooden base is simplest. i was hoping for something lower profile though to show off my TS restoration.
any ideas for this?
thanks a lot,
andy
i have an old unisaw with the 52" bies fence..a 7518 and router lift and i'm getting the 17" incra super system that will attach to the table top like keith's in the above thread.
is there a mobile base available that would work with this kind of setup? i was thinking delta until i realized the lifting castor wouldn't be accessible. i'd like to butt the cabinet as close as i can with the hand crank on the TS.
is this the project where i finally learn how to weld...or maybe a wooden base is simplest. i was hoping for something lower profile though to show off my TS restoration.
any ideas for this?
thanks a lot,
andy