Kevin Womer
10-22-2010, 6:23 PM
Received the router today I had asked about on a previous thread. It will replace my Dewalt 621 as the bearings are shot. Ordered a Woodpecker's router plate and it was shipped today, so will have to wait to get it in my table.
I am impressed with this router especially the winder method of plunging. I am excited to get it in a table and use the above table winder handle to change bits- that will be a new experience for me. It comes with a fence and both 1/4 and 1/2 inch collets. I haven't noticed the soft start issue I had read about on some online reviews, but it will be mainly used in a table anyway. Thanks again to all who offered their insight and made my decision an easy one, I appreciate it.
Take Care,
Kevin
I am impressed with this router especially the winder method of plunging. I am excited to get it in a table and use the above table winder handle to change bits- that will be a new experience for me. It comes with a fence and both 1/4 and 1/2 inch collets. I haven't noticed the soft start issue I had read about on some online reviews, but it will be mainly used in a table anyway. Thanks again to all who offered their insight and made my decision an easy one, I appreciate it.
Take Care,
Kevin