Stuart Orrell
09-23-2010, 9:13 AM
Hi all,
I have been asked to cut some large pieces of veneer. Could be up to approximately 500mm X 350 mm.
Any recomendations as to the best way to hold it flat and ripple free while cutting? After cutting, I would like to keep and use the cut and un-cut areas, so prefereably, the glue or tape or ????? would just be temporary.
Look forward to your suggestions.
I have been asked to cut some large pieces of veneer. Could be up to approximately 500mm X 350 mm.
Any recomendations as to the best way to hold it flat and ripple free while cutting? After cutting, I would like to keep and use the cut and un-cut areas, so prefereably, the glue or tape or ????? would just be temporary.
Look forward to your suggestions.