mreza Salav
09-19-2010, 11:51 PM
I inherited this Clearvue system and brought home today.
I started looking at his setup and it appears to me he has placed the taperlock between the impeller and the motor (wheres the instructions says to put it over the impeller). I loosened the three bolts that go through the impeller and I think tighten the taper lock. See the photos bellow (the 1st shows with the bolts taken out, the 2nd shows the bolts placed but not tightend, the 3rd photo shows between the impeller and the MDF piece that is bolted to the motor):
161970161968161969
I don't know how he has tightened the setscrew (if he ever has done it) but i cannot take the impeller off of the shaft even after I take those three bolts out.
Any ideas how to proceed? There is some damage done (during dis-assembly and shipping) to the MDF piece that is attached to the motor and I want to replace it and but I cannot do it unless I take the impeller off.
Should I use some WD40?
I started looking at his setup and it appears to me he has placed the taperlock between the impeller and the motor (wheres the instructions says to put it over the impeller). I loosened the three bolts that go through the impeller and I think tighten the taper lock. See the photos bellow (the 1st shows with the bolts taken out, the 2nd shows the bolts placed but not tightend, the 3rd photo shows between the impeller and the MDF piece that is bolted to the motor):
161970161968161969
I don't know how he has tightened the setscrew (if he ever has done it) but i cannot take the impeller off of the shaft even after I take those three bolts out.
Any ideas how to proceed? There is some damage done (during dis-assembly and shipping) to the MDF piece that is attached to the motor and I want to replace it and but I cannot do it unless I take the impeller off.
Should I use some WD40?