Jeff Paxton
09-13-2010, 11:56 AM
I have been wanting to try my hand at piercings. I have been looking at the NSK Presto which can be seen here:
http://www.woodturnerscatalog.com/store/Carving___Pyrography___Carving___NSK_Presto_High_S peed_Carver___nsk_carver?Args
I have an air compressor with the following specs and I was wondering if you just hook the tool directly into the hose coming from the compressor? Would my compressor work, or would I need something different? I don't know much about it, so if someone could explain the process I would appreciate it. Is this a good tool, or is there some other recommendation?
Here are the specs from the side of my compressor: (not sure what it all means)
20 Gallon
5 hp
11.9 CFM
8.8 SCFM @ 40 psi
6.9 SCFM @ 90 psi
Thanks for any help,
Jeff
http://www.woodturnerscatalog.com/store/Carving___Pyrography___Carving___NSK_Presto_High_S peed_Carver___nsk_carver?Args
I have an air compressor with the following specs and I was wondering if you just hook the tool directly into the hose coming from the compressor? Would my compressor work, or would I need something different? I don't know much about it, so if someone could explain the process I would appreciate it. Is this a good tool, or is there some other recommendation?
Here are the specs from the side of my compressor: (not sure what it all means)
20 Gallon
5 hp
11.9 CFM
8.8 SCFM @ 40 psi
6.9 SCFM @ 90 psi
Thanks for any help,
Jeff