table saw miter jig

[Karl Card]

I could be wrong but it seems when I first started this forum I found a jig link or directions or something within the forum for a sled to use on my table saw to cut perfect miter corners, for picture frames etc...I liked the design in that even if the cut was off a degree or so it did not mess the project up because the other side would be over a degree.

I dont mean to be ignorant on this subject but I really just dont know how to explain this jig with the proper words.

Thanks for any info

[Bryan Wellman]

This is one I was going to make. Simple design, and like you mentioned...doesn't matter if your off a touch, the angles will always be square!! :)


http://www.woodworkersguide.com/2008/02/26/the-perfect-picture-framer-jig/

[glenn bradley]

I made an add on for my large sled. I have made a second generation that is a bit more sophisitacated but, here' s the original: http://www.sawmillcreek.org/showthread.php?t=120289&highlight=miter

[Karl Card]

This is one I was going to make. Simple design, and like you mentioned...doesn't matter if your off a touch, the angles will always be square!! :)


http://www.woodworkersguide.com/2008/02/26/the-perfect-picture-framer-jig/


this is exactly the one I saw... thanks so much....