PDA

View Full Version : Maxie - Press?



Gail LaPorte
07-03-2010, 7:10 PM
Hi not sure where this would be asked so here goes. I have a Maxi-Press with the two attachments that go with it but no book,I am looking for a copy of it so i can learn how to use it with out having to keep playing with it.I have tried looking on line but no luck .

Thanks
Penny

Larry Bratton
07-03-2010, 8:09 PM
Probably not the best place...but..go to this link for an owner's manual
http://www.heatpress.com/support.php
Good luck

Tony Lenkic
07-03-2010, 8:10 PM
Penny,

Here is a place you can ask if they have any documentation.
http://www.maintrophysupply.com/presses.htm

I reality it is a simple tool to operate. Long slider is for last picture "center holes". Short one does most of corner notching & holes. For corner rounding use very top cylinder motion. Also, on the right side of the assembly there is a sliding pin to restrict handle motion to 12 o clock position for notching only.
If you have specific ? we can address it as well.

Congrats, very useful tool.