Rockwell Model 10 fence problem

[Clif Moore]

I inherited my dad's Model 10 when he got a Unisaw. I used info on this forum to align the blade and miter slot via a PALS system. However, the fence is out by an eighth of an inch at the far end of the fence. I do not have the manual. Is there a way to adjust the fence to make it parallel to the saw blade? Oh, forgot to mention this tis the original fence that came with the saw.

[mark kosse]

Original fence? That could be a lot of fences. Mine 10 came with a Biesemeyer HS. A pic would help. If it's a jet lock, the 2 bolts on top of the fence towards the lock allow for adjustment.

Hope it helps

[Clif Moore]

Thanks, Mark. I believe it is a jet lock. I am assuming you mean the two screws on top of the fence near the locking mechanism. I'll try loosening them and aligning the fence.

Clif

[Clif Moore]

Thanks, Mark. That did the trick.

Clif

[mark kosse]

Your in business now. It's a fine saw. Good luck.