View Full Version : Wireless Computer connection Epilog Mini

Alan Moberly
06-16-2010, 9:14 AM
Hi, I have been a member lurking here for sometime. This is my first post and it is a question. I have been running my Mini 18 off of the wired local network successfully. I wanted to be able print from my laptop which connects by wireless connection. I have it connected using a standard TCP/IP port. I am not able to get a print job through to the printer. Is a standard TCP/IP the type of port I want to use for a wireless connection.


Anthony Scira
06-16-2010, 10:11 AM
I have a reply in this post to set up your computer in this thread.


should work for you. Sounds like a driver misconfiguration on your laptop since your wired computers are working.

Alan Moberly
06-16-2010, 10:41 AM
I found the problem. All of the paperwork I had gathered on my network settings said that the ip address on the laser was 105. I finally physically checked the ip address on the laser control panel and it was 106. Needless to say I have updated my paper work.

Anthony Scira
06-16-2010, 11:23 AM
Amazing how much trouble one little number can be..........

Michael Kowalczyk
06-16-2010, 1:03 PM
Especially in a digital world where you are either considered the best, #1, or the worst (a Zero), #0.:confused: but they are all equal, right?:rolleyes: