Easy Rougher type tools

[Bill Bulloch]

Was I just having a dream or did I read a thread on here one time about someone who makes Easy Rougher/Finisher types tools at a reasonable price and the mention of a site where the cutting heads could be found cheap. I can't find that thread now.

If I wasn't just dreaming, does anyone know anyone who does this type work on the cheap? I'd like to try them out, but don't want to invest the $250 it would cost to test the real thing.

[Tim Rinehart]

http://sawmillcreek.org/showthread.php?t=138537

[Harvey M. Taylor]

Bill, sent you a pm. Max

[Kyle Iwamoto]

You can get a Byrd cutter from Griz. 30 bucks for a pack of 10.

[Jamie Straw]

Perhaps you're remembering the J&B "Peeler"?? It has a square shaft, which seems to be an advantage over some of the other knock-offs.
http://www.jandbtools.com/products.php

[bryan stanley]

Not trying to sell anything here,but it is not that hard to make a lathe tool with carbide inserts. I have made a few more my fellow call makers with good results specially when turning hard woods , aluminum or brass. Folks are right a square tool shaft does work better than a round one indeed.

http://i798.photobucket.com/albums/yy270/SanctuaryCalls/Tool002.jpg
http://i798.photobucket.com/albums/yy270/SanctuaryCalls/Tool004.jpg
http://i798.photobucket.com/albums/yy270/SanctuaryCalls/Tool005.jpg

[brian watts]

Bill this is one of a few i have made so far.. not that hard to make ..firewood red oak handle .pic not that great sorry