View Full Version : About to canabalise for parts...
Brian Greb
06-10-2010, 9:27 AM
I just got a # 12 scraper plane bed and well I only need the frog and cap. So i was wondering if there is a proper way to remove them... I'd like to cause as little damage as possible. Can I punch out the pin or do I need to drill it out?
Thanks
-Brian-
James Taglienti
06-10-2010, 3:13 PM
you should be able to drive the pin out. Make sure you use the right size punch because that pin is soft steel. careful of the casting, too, but i guess you dont need it anyway.
Someone once told me that the pin only goes one way. Ive removed a couple but i don't know which way i went.
Brian Greb
06-10-2010, 6:22 PM
you should be able to drive the pin out. Make sure you use the right size punch because that pin is soft steel. careful of the casting, too, but i guess you dont need it anyway.
Someone once told me that the pin only goes one way. Ive removed a couple but i don't know which way i went.
thank you James
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.