Daniel Shnitka
06-05-2010, 1:15 AM
A long shaft (30 cm nearly 12 inches in length) with 5/32 Allen hex head screw driver is needed to to speed above the table router bit changes.
I have had no luck in my search on the internet or locally for such a screwdriver.
I came across a "long shaft" 30 cm in length screw driver, however it had a Robertson square driver bit inserted in the end.
I was thinking of removing the Robertson head bit using heat and force with the bit clamped in a heavey duty vise. It is that or cutting the Robertson head driver it off just down the shaft a little past where the bit is inserted. It would then need to be end drilled. A hole large enough in the end of shaft to accept a cut off piece of 5/32 allen key hex wrench.
I do not have acess to a welder though I could possibly sodder the drill hex bit in the hole.:confused:
I have had no luck in my search on the internet or locally for such a screwdriver.
I came across a "long shaft" 30 cm in length screw driver, however it had a Robertson square driver bit inserted in the end.
I was thinking of removing the Robertson head bit using heat and force with the bit clamped in a heavey duty vise. It is that or cutting the Robertson head driver it off just down the shaft a little past where the bit is inserted. It would then need to be end drilled. A hole large enough in the end of shaft to accept a cut off piece of 5/32 allen key hex wrench.
I do not have acess to a welder though I could possibly sodder the drill hex bit in the hole.:confused: