Bill Huber
05-31-2010, 1:50 PM
When I made my router table stand I set it up so I would have enough space under it for a shop vac. I don't have a big DC and I don't think with the space I have I will ever get one.
So I put 2 drawers on the side for bits, that worked for awhile but then I had to add a rack on the wall. That worked for awhile and then I had to keep some of the bits in a drawer under the bench.
I checked and I had just enough space between the shop vac and the bottom of the table to add a draw.
The drawer is 22 x 22 and I think now I will have enough space for all my bits in one place, well until next week.:D
I used the foam blocks to hole the bits, I tested some different ways of doing it but the foam blocks came out as the best over all. It sure is nice to have all the bits in one place and out of the way.
152020 152019
So I put 2 drawers on the side for bits, that worked for awhile but then I had to add a rack on the wall. That worked for awhile and then I had to keep some of the bits in a drawer under the bench.
I checked and I had just enough space between the shop vac and the bottom of the table to add a draw.
The drawer is 22 x 22 and I think now I will have enough space for all my bits in one place, well until next week.:D
I used the foam blocks to hole the bits, I tested some different ways of doing it but the foam blocks came out as the best over all. It sure is nice to have all the bits in one place and out of the way.
152020 152019