View Full Version : Font help please
Mike Christen
05-28-2010, 2:40 PM
Hello all
Having a problem locating this font, any one have any idea. I tried what the font in corel and searched my fonts but no luck. Can' seem to find anything even close to the "f"
Thanks
Liesl Dexheimer
05-28-2010, 3:43 PM
That kind of reminds me of New Hermes/Gravograph Block 513 but I'm not really sure, sorry I can't be of more help.
Dave Russell Smith
05-28-2010, 5:09 PM
This what I've come up with
"Threepoints East"
Type Associates Threepoints East
Tony Lenkic
05-28-2010, 10:38 PM
Mike,
That is perfect match of Gothic font from Xenetech. I use it daily with my rotary engraver.
Mike Christen
05-28-2010, 10:40 PM
Thanks Dave, that is the f.
I hate trying to match fonts, very time consuming.
Mike Christen
05-28-2010, 10:43 PM
Thanks Tony
To bad the rotary fonts don't have ttf conversions, at least i haven't seen them. all proprietary.
Tony Lenkic
05-28-2010, 10:50 PM
Mike - Is this a large job or just few plates you are working on?
Mike Christen
05-28-2010, 11:21 PM
Hi Tony
Just a few plates now but more in the future i think
Tony Lenkic
05-28-2010, 11:31 PM
Mike - If you have to match it I would suggest you look at Lamro Gothic TTF for use with Corel. Check out their site below in the yellow column.
http://www.lamro.com/fonts/truetype/truetype.htm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.