PDA

View Full Version : Font help please



Mike Christen
05-28-2010, 2:40 PM
Hello all

Having a problem locating this font, any one have any idea. I tried what the font in corel and searched my fonts but no luck. Can' seem to find anything even close to the "f"

Thanks

Liesl Dexheimer
05-28-2010, 3:43 PM
That kind of reminds me of New Hermes/Gravograph Block 513 but I'm not really sure, sorry I can't be of more help.

Dave Russell Smith
05-28-2010, 5:09 PM
This what I've come up with
"Threepoints East"
Type Associates Threepoints East

Tony Lenkic
05-28-2010, 10:38 PM
Mike,

That is perfect match of Gothic font from Xenetech. I use it daily with my rotary engraver.

Mike Christen
05-28-2010, 10:40 PM
Thanks Dave, that is the f.

I hate trying to match fonts, very time consuming.

Mike Christen
05-28-2010, 10:43 PM
Thanks Tony

To bad the rotary fonts don't have ttf conversions, at least i haven't seen them. all proprietary.

Tony Lenkic
05-28-2010, 10:50 PM
Mike - Is this a large job or just few plates you are working on?

Mike Christen
05-28-2010, 11:21 PM
Hi Tony

Just a few plates now but more in the future i think

Tony Lenkic
05-28-2010, 11:31 PM
Mike - If you have to match it I would suggest you look at Lamro Gothic TTF for use with Corel. Check out their site below in the yellow column.


http://www.lamro.com/fonts/truetype/truetype.htm