Liesl Dexheimer
05-27-2010, 11:15 AM
HELP!
I was just about at the end of a job and I received an X/Y Disabled: X message on our Epilog mini engraver. It seems like the cord is getting stuck because it's engraving a 2.5" x 24" piece. I turned off the machine and restarted it, sent the job over, it got only a few passes down and then stopped with that error message again. Any suggestions?
I was just about at the end of a job and I received an X/Y Disabled: X message on our Epilog mini engraver. It seems like the cord is getting stuck because it's engraving a 2.5" x 24" piece. I turned off the machine and restarted it, sent the job over, it got only a few passes down and then stopped with that error message again. Any suggestions?