Brian Buckley
11-20-2004, 10:00 PM
I finally got my MM 20 up and running. My electrician Brother in Montana talked me through wireing it over the phone. He thinks it is funny that I can build hot rods from scratch, weld pretty well, do fair woodworking, but cant wire a light bulb.
Set up went smoothly. Removeing it from the pallet went just like several of you told me.
I have been monkeying around this evening trying to cut thin vaneers off of a pine 1 x 4. It will cut 1/32 with ease. The finish is not as smooth as I had hoped. I suspect I do not have the blade tension correct. I am going to tighten it some more and see what the results are. I dont have much confidence in the tensioning guage.
The blade I am useing is a 1" 2/3 TM Lenox.
Tyler, I will try and post pictures tomorrow.
Brian
Set up went smoothly. Removeing it from the pallet went just like several of you told me.
I have been monkeying around this evening trying to cut thin vaneers off of a pine 1 x 4. It will cut 1/32 with ease. The finish is not as smooth as I had hoped. I suspect I do not have the blade tension correct. I am going to tighten it some more and see what the results are. I dont have much confidence in the tensioning guage.
The blade I am useing is a 1" 2/3 TM Lenox.
Tyler, I will try and post pictures tomorrow.
Brian