Dennis Lopeman
05-14-2010, 1:17 PM
I hope this is a quick question - I just have had time to peruse lately since I have too much work to do at work... go figure!!!
I'm using 10mm Barrel Hinges... and I used a 10mm drill bit - but the holes are SOOOO tight and can't push them down into the holes very well... not to mention if once I do get them in there, what if I need to adjust and turn them slightly.
What's the secret? I haven't had time to research either, so if there's a thread, please direct me!
TIA!
I'm using 10mm Barrel Hinges... and I used a 10mm drill bit - but the holes are SOOOO tight and can't push them down into the holes very well... not to mention if once I do get them in there, what if I need to adjust and turn them slightly.
What's the secret? I haven't had time to research either, so if there's a thread, please direct me!
TIA!