Amana bit

[Louie Ballis]

Does anyone have any experiance with the Amana box joint bit? Its for a router table and will allow you to cut some pretty small box joints which would be great for drawers in a jewelry chest.

These bit from what I can tell cut 1/2 inch material up to 1.5 inches high.

I like the idea and the simplicity of using these for a small drawer, but before I shell out around 100 for a bit I need some assureance.


thanks

Louie

[Robby Tacheny]

I have an Amana 3/4 inch straight bit and it is great. I have used it for box joints and had no problems.I would imagine the 1/2 inch is just as good.

-R