Louie Ballis
05-13-2010, 6:23 PM
Does anyone have any experiance with the Amana box joint bit? Its for a router table and will allow you to cut some pretty small box joints which would be great for drawers in a jewelry chest.
These bit from what I can tell cut 1/2 inch material up to 1.5 inches high.
I like the idea and the simplicity of using these for a small drawer, but before I shell out around 100 for a bit I need some assureance.
thanks
Louie
These bit from what I can tell cut 1/2 inch material up to 1.5 inches high.
I like the idea and the simplicity of using these for a small drawer, but before I shell out around 100 for a bit I need some assureance.
thanks
Louie