George Guadiane
05-02-2010, 11:55 AM
Some people have commented about the Munro hollowers clogging up. I have had a bit of trouble in that area, but not often and not for long (rotate or change the cutter).
I HAD been having trouble keeping the articulation set where I put it...
First of all, I'm using it a lot with the Monster setup and secondly, I'm a bit of a thug when roughing out...
I use an extra link on them to increase the ability to articulate, and REALLY think it's worth the money since it's a one time thing. I went out and bought new bolts & screws, since I seem able to strip them out a bit, AND (and this is the most important part) I took them all apart and :eek: CLEANED THEM :eek::rolleyes:.
It seems that little bits of dust and stuff manage to get in between the joints and prevent good tightening. Most of you probably either are not so rough on your tools or already know this, but for the other one or two, I thought I might share this to make life better for you too.
I HAD been having trouble keeping the articulation set where I put it...
First of all, I'm using it a lot with the Monster setup and secondly, I'm a bit of a thug when roughing out...
I use an extra link on them to increase the ability to articulate, and REALLY think it's worth the money since it's a one time thing. I went out and bought new bolts & screws, since I seem able to strip them out a bit, AND (and this is the most important part) I took them all apart and :eek: CLEANED THEM :eek::rolleyes:.
It seems that little bits of dust and stuff manage to get in between the joints and prevent good tightening. Most of you probably either are not so rough on your tools or already know this, but for the other one or two, I thought I might share this to make life better for you too.