PDA

View Full Version : Laser pro print driver question



Mitchell Andrus
04-30-2010, 1:54 PM
I typically vector cut and prefer 85 power for most materials. I'd like to change the pre-sets for a few of the colors so I can avoid changing the power settings with each new file sent.

Red = power 75 to Red = power 85 for example.

Does anyone know the .ini file where this is stored? I've looked at the ones I could find but can't find a "75" anywhere.

TIA
.

Chuck Stone
04-30-2010, 8:22 PM
I don't know if it is in an ini file, but I think you can do it under the
Printer Properties in the Control Panel. And you can save the settings
as a MER file which will come up in the printer dialog box when you
select File --> Print.

Or is that too obvious and I missed something?