Stephen Beckham
04-12-2010, 11:00 AM
Guys and Gals, just had a scratch the head moment followed by holding my breath cause I was stumped. Counted to 10 and started all over again.
Sent a job to the Mini 24 and it would finish loading. When I hit go, it would always say "Not Ready Yet"
Long story short - I was printing in Top-Center Mode and the picture had hidden pixels above the zero line. Looking at the image with nothing selected, it was below the line, but when selected, it was slightly above the line of the printable area.
SO, if you have the top of you image off the top of the printable area and are trying to print Top-Center, the solution is to Tighten up the Loose-Nut between the keyboard and the chair....
Probably the same solution for a lot of our problems.... :eek:
Sent a job to the Mini 24 and it would finish loading. When I hit go, it would always say "Not Ready Yet"
Long story short - I was printing in Top-Center Mode and the picture had hidden pixels above the zero line. Looking at the image with nothing selected, it was below the line, but when selected, it was slightly above the line of the printable area.
SO, if you have the top of you image off the top of the printable area and are trying to print Top-Center, the solution is to Tighten up the Loose-Nut between the keyboard and the chair....
Probably the same solution for a lot of our problems.... :eek: