Ian Wilson (AUST)
04-08-2010, 12:53 AM
Dear Creekers,
I have just received an order for about 500 30mm x 100mm (approx 1 inch x 3 Inch) signs. Material used Rowmark.
The signs are square with rounded corners and I would like to line them up so the sides overlap exactly so when I go to cut one pass will equal two sides being cut ( reducing time and material). At the moment I can only get Corel and my Epilog to cut 4 sides per sign each time ie double cutting the sides and making them extra "sticky".;)
Will the weld tool fix this??
Kind regards,
Ian
I have just received an order for about 500 30mm x 100mm (approx 1 inch x 3 Inch) signs. Material used Rowmark.
The signs are square with rounded corners and I would like to line them up so the sides overlap exactly so when I go to cut one pass will equal two sides being cut ( reducing time and material). At the moment I can only get Corel and my Epilog to cut 4 sides per sign each time ie double cutting the sides and making them extra "sticky".;)
Will the weld tool fix this??
Kind regards,
Ian