Hollow Form #2

[Brad Vaughn]

I found a Article by Bob Hamilton on Turning a Potpourri hollow form.
Link:http://bobhamswwing.com/Articles/Roundpotpourri/Turning%20a%20Round%20Potpourri.htm

His method was simple on paper and I found it to be the same on the lathe.
The two woods are from a bunch of scrap that I have.
C&C welcome
I think it looks like a donut. I am going to add a top to the hole I am thinking short and fat.

[John Keeton]

Looks nice, Brad. On your next one you may want to look at the cast tops at CSUSA, and some other suppliers. Might be an extra little touch.

[Brad Vaughn]

Looks nice, Brad. On your next one you may want to look at the cast tops at CSUSA, and some other suppliers. Might be an extra little touch.

Yep I have some on the way.
I was thinking a this could have been a paper clip holder to

[Bernie Weishapl]

Looks really good Brad.

[Mike McAfee]

Nice work Brad! I've been thinking about ordering a few of the cast lids John refers to so I can actually finish some of these "not quite sure what to do with it" smaller forms I have accumulating!

[David E Keller]

It looks good... especially for a second hollow form.

It is a bit squatty, but it looks nicer than a lot of the stuff I've turned.

[Baxter Smith]

They look good Brad. Some interesting other projects at the link you supplied as well.