View Full Version : Tool gloat
Brian Greb
03-19-2010, 8:11 PM
I went to rockler today and low and behold I found this sorby hollowing set on clearance... $87 can't beat that so I got'em. and I know if there isn't a pic then it doesn't count.. so...
Ron Erickson
03-19-2010, 8:35 PM
Look's good now get them dirty. Ron
John Tomasello jr
03-19-2010, 8:46 PM
Have the same set, do not remember what I payed. Don't use the center borer much rather use a drill bit.
Roland Martin
03-19-2010, 8:49 PM
Nice set. There's no end to the $ we spend.
Mark Hubl
03-19-2010, 9:40 PM
Brain,
That is a good starter set. I have it and use it often. I will offer a word of warning though, the swan neck with the movable cutter is a catchy son of a gun. Proceed with caution. I have never got the hang of that tool. Good luck.
Bernie Weishapl
03-19-2010, 10:02 PM
Congrats on a nice tool gloat.
Steve Schlumpf
03-19-2010, 10:09 PM
Congrats on our new hollowing tool set! Looking forward to seeing what you turn using them!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.