View Full Version : quick question
fred sanchez
03-18-2010, 12:11 AM
can you engrave polypropylene ?
Mike Chance in Iowa
03-18-2010, 12:23 AM
If you use the SEARCH feature on this forum, you will find all the answers you need. ;)
Mike Null
03-18-2010, 4:30 AM
Fred
I went to the Synrad applications site and did not find any entries but here is a German site which indicates cutting and marking are good but engraving is iffy.
http://www.eurolaser.com/en/materials/cutting/polypropylene-pp/
fred sanchez
03-18-2010, 10:43 AM
thanks guys
Michael Hunter
03-18-2010, 1:05 PM
For some reason, polypropylene (and polyethylene) don't vapourise well, but melt under the heat of the laser.
You just end up with a puddle of molten plastic and when it's set hard again the "engraving" is barely visible.
For cutting it, you needs lots of power and air-assist to blow away the molten stuff.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.