Logosol PH260 Moulder - overkill for the small shop ?

[Alex Silva]

Get rid of your jointer and buy this : http://www.logosol.com/planers/ph260/

Same amount of floor space, 1 or 3 phases... and only 10K !!

I need one already !

alex

[Mike Heidrick]

Super sweet!

[Jim Dailey]

The Logosol is a sweet 4 sided molder. But a 10k it should... And it doesn't stop a 10k 'cause the 4 motors require a serious vacuum set up that looks like an octopus. Don't get me wrong I'd love one, just could come close to affording one.

But for less than 1/2 the price you could get a Woodmaster set up with twin Milwaukee routers on the out feed side on either the 18" or 25" model that will do 3 sided moldings. And have a wider selection of profiles from literally hundreds of sources. The twin router w/additional out feed roller is about a 2k option and there is a readily available supply of good used 18" & 25" Woodmasters available.

jim

[Alex Silva]

can you go from rough direct to S3S with the woodmaster or you need to joint the board before ?

Cheers,

Alex

[Paul Atkins]

A friend has one and loves it. I'm going to need some flooring and he said it was just the ticket-since he has the knives already.