Shop improvements

[Todd Reinbold]

I recently finished a big built in cabinet job and decided to do a few shop improvements. Built a outfeed table for the new-to-me PM66 5hp tablesaw.144759

[Van Huskey]

Also very nice, I love the true gold 66, wish I had a cast extension on my PM2000 like that.

[glenn bradley]

I like it, I like it. This may be the inspiration for me to finally re-do the re-purposed metal lab table/particle board "temporary" outfeed I have been using since forever.

[J D Thomas]

Todd, what kind levelers did you use? And where did you get them?

[Tony Shea]

I likes. Good idea to add drawer space below the outfeed table. That is inspiration for me as my outfeed table is just wasted space below the table. Thanks as I am always in need of extra storage.

[Chip Lindley]

Good Job at utilizing all that space! It's a MUST since a TS makes such a huge footprint in the shop! Your PM66 is a TRUE Oldie Goldie!

[Terry Hatfield]

Nice design Todd. I like it! Especially like the drawers in the end. Makes good sense and is an excellent use of the space. Like one of the other posters, I don't have storage under my outfeed bench but I might pretty soon. :D

t

[Todd Reinbold]

JD , If I remember right, I bought the levelers from Rockler awhile back. They have a 1/2 " thread on them. I used some of those long nuts that are used to connect threaded rod together, and epoxied them into the legs for the levelers to screw into.

[Don Bullock]

Oh do I wish I had one just like it. Todd, that's great. Thanks for sharing.