Glen Butler
03-08-2010, 11:17 AM
I have the PC Omnijig, but I have a hard time getting Porter Cable router bits in these parts. Freud are easy to come by and CMT is OK. I am having trouble finding out the size of the different omnijig bits so I can match them. The D4 I know is a 1/2" OD. I don't know the angle. I think 7*. What problems will using an 8* bit cause? or even 14*? Freud has some bits that are close bit not quite the same.
Bottom line is how critical is it to use the exact bit PC recommends? Is it all a matter of making sure the stops and templates are set up for the bit you are using?
Bottom line is how critical is it to use the exact bit PC recommends? Is it all a matter of making sure the stops and templates are set up for the bit you are using?